This page is being updated with
new information!
Therefore please contact ATLAS
DCS before using the information below for new
designs for the latest information!
Please note that older Motherboards MB2 and ELMBs
using +5V should be returned because they will not longer be supported!
| Technical
drawings of the single board implementation
of the Embedded Local Monitor Box ELMB103 3.3V version only |
||||
| Items available |
|
|
Comments | |
|
|
Introduction and general description elmb 5.html updated 29.12.2000 |
|
|
also available
in pdf format 573 kbytes |
|
|
On the SEE protection of the ELMB with the onboard regulators MIC5203 |
|
|
in pdf format |
|
|
The Manual of the CAN Branch Power Monitor Box for use at the TCC2 tests for SEE detection ver 0.2 |
|
|
in pdf format |
|
|
The latest version of the ELMB has 3.3V processors. Picture of front side |
|
|
in html format |
|
|
Picture of back side (64 channel differential 16+ 7bit ADC) |
|
|
in html format |
|
|
Blockdiagram of the ELMB |
|
|
in pdf format |
|
|
Schema of CAN (top part of the pcb) for 3.3V |
|
|
in pdf format |
|
|
Schema of ADC (bottom part of the pcb) for 3.3V |
|
|
in pdf format |
|
|
Pin out of the two connectors J1 and J2 2*50 pins Bergtac for 3.3V |
|
|
in pdf format |
|
|
Bergtac Connector 61082 mounted on ADC side of ELMB |
|
|
in pdf format |
|
|
Bergtac Connector 61083 mounted on motherboard |
|
|
in pdf format |
|
|
Schema of the motherboard |
|
|
in pdf format |
|
|
Mechanical drawing of motherboard
for new ELMB3 2x50 pin connector implementation
This ELMB is increased in size with 1mm 50.3x67 mm instead of 50x66 mm (updated with mounting holes and photo) |
|
21.2.2002 | in pdf format |
|
|
Picture of the front side of the motherboard |
|
|
|
|
|
Picture of the back side of the motherboard |
|
|
|
|
|
Pin out of the connectors on the motherboard (updated for 3.3V) |
|
|
in html format |