ELMB128
Embedded Local Monitor Boardwith the ATmega128L processor
Last updated 6.5 2004
The ELMB128 board is a pin-compatible upgrade of the ELMB board featuring an ATmega128 instead of an ATmega103 processor, and without the second processor (AT90S2313) plus some other (minor) hardware modifications. There will be two versions one complete with on-board 16+7 bits ADC CS5523 called ELMB128-A and one digital without the ADC called ELMB128-N. A new software feature of the ELMB128-A is the calibration to better than ±0.2% done at the production on all ranges including the 5V range. This range is calibrated to +5V and not +4.2V as for the previous version of the ELMB.
| General introduction and description of the ELMB128 |
|
| The embedded software is
made by Henk
Boterenbtood NIKHEF |
|
| For hardware general questions, the use of the
ELMB in radiation, technical support and production of the ELMB
board
contact Bjorn
Hallgren CERN PH-ATE. |
|
| Technical
documentation of ELMB128-A schematic, pcb information are available here EDMS http://edms.cern.ch/item/CERN-0000010235/1 |
 |
| Technical
documentation of ELMB128-D schematic, pcb information are available here EDMS http://edms.cern.ch/item/CERN-0000010975/0 |
|
| This page contains
technical
notes and other information about the ELMB128 |
|